剛開始學SolidWorks.版本為2006SP4.1的.在跟它的幫助教學課程學習到(指導教程
輸入 AutoCAD 文件展示如何輸入 AutoCAD 工程圖并進行修改)這一課程時候發現這一小段課程是E文的.無法繼續學習操作.求哪位能幫助指導一下.我現在連這一步都進行不下去了.不知道如何去做.謝謝.
Make sure that Create new SolidWorks drawing and Convert to SolidWorks entities are selected.
4 U. l n# n0 A J+ C) ? bClick Next.
/ V! W1 r7 I6 |% QClick Next to accept the defaults on the Drawing Layer Mapping screen.
Under Geometry positioning, select Center in sheet to center the imported drawing on the drawing sheet.
8 ~1 l2 j$ A7 p! QClick Finish.
歡迎光臨 機械社區 (http://www.mg7058.com/) | Powered by Discuz! X3.4 |